Beer hoses
The beer hose carries the beer from the coupler to the cooler and on to the tap. We offer it ready-made for direct connection, by the metre for your own lengths, or assembled to your requirements.
Ready-made beer hoses
The ready-made hoses come with ID 7 mm or ID 10 mm, 150 or 300 cm long, with a wing nut or hex nut 5/8". The hose tails are straight or bent by 90° at one end – useful when the hose needs to run straight to the side or downwards. There are also 3/8" hoses with two 5/8" push-fit connections.
By the metre, on the roll or made to measure
For your own lengths there are soft, transparent hoses with ID 7 and ID 10 mm as well as hard, milky hoses with 3/8" (OD 9.5 mm) – by the metre or on the roll. The thin hoses with ID 4 mm and OD 8 mm are suitable for beer and CO2. Or configure your hose in NW 4, 7 or 10 and receive it fully assembled.
Which hose fits?
- The inner diameter should match the nominal width of the cooler: NW 7 → ID 7 mm, NW 10 → ID 10 mm.
- Beer connections on coupler, cooler and font usually have a 5/8" thread.
- Individual nuts, hose tails and clamps can be found under connections & fittings, hoses for the gas side under CO2 & air hoses.